- 您现在的位置：买卖IC网 > Sheet目录17338 > EL7554IRE-EVAL (Intersil)DEMO BOARD FOR EL7554
EL7554
V O close to V IN . The maximum achievable V O is:
V O = V IN – ( R L + R DSON1 ) × I O
Where R L is the DC resistance on the inductor and R DSON1
is the PFET on-resistance, nominal 35m Ω at room
EL7554
C OSC
100pF
EXTERNAL SYNC
SOURCE
V O = 0.8 × ? 1 + ------- ?
temperature with tempco of 0.2m Ω /°C.
Output Voltage Selection
The output voltage can be as high as the input voltage minus
the PMOS and inductor voltage drops. Use R 1 and R 2 to set
the output voltage according to the following formula:
? R 1 ?
? R 2 ?
Standard values of R 1 and R 2 are listed in Table 1.
TABLE 1.
FIGURE 20. EXTERNAL SYNC CIRCUIT
Thermal Protection and Junction Temperature
Indicator
An internal temperature sensor continuously monitors the
junction temperature. In the event that the junction
temperature exceeds +135°C, the regulator is in a fault
condition and will shut down. When the temperature falls
back below +110°C, the regulator goes through the soft-start
procedure again.
The V TJ pin is an accurate indicator of the internal silicon
junction temperature T J , which can be determined by the
V O (V)
0.8
1
1.2
1.5
1.8
2.5
3.3
R 1 (k Ω )
2
2.49
4.99
10
12.7
21.5
36
R 2 (k Ω )
Open
10
10
11.5
10.2
10
11.5
following formula. This saves engineering time.
0.00384
1.2 – V TJ
T J = 75 + ------------------------
where VTJ is the voltage at VTJ pin.
Under-Voltage Lockout (UVLO)
When V DD falls bellow 2.5V, the regulator shuts down. When
V DD rises above 2.8V, converter goes through soft-start
process again.
Power Good Indicator (PG) and Over-Voltage
Voltage Margining
The EL7554 has built-in 5% load stress test (commonly
called voltage margining) function. Combinations of TM and
SEL set the margins shown in Table 2. When this function is
not used, both pins should be connected to SGND, either
directly or through a 10k Ω resister. Figure 16 shows this
feature.
TABLE 2.
Protection
When the output reaches 10% of the preset voltage, the PG
pin outputs a HI signal as shown in the start-up waveform
(Figure 12). If the output voltage is higher than 10% of the
preset value for any reason, PG will go low and the regulator
will shut down. In addition to the indication power is good,
the PG pin can be used for multiple regulators’ start-up
control as described in the next section.
CONDITION
Normal
High Margin
Low Margin
TM
0
1
1
SEL
X
1
0
V O
Nominal
Nominal + 5%
Nominal - 5%
Full Start-Up Control
The EL7554 offers full start-up control. The core of this
control is a start-up comparator in front of the main PWM
controller. The STP and STN are the inputs to the
comparator, whose HI output forces the PWM comparator to
skip switching cycles. The user can choose any of the
T ST = RC ? --------- ?
Switching Frequency
The regulator operates from 200kHz to 1MHz. The switching
frequency is generated by a relaxation comparator and
adjusted by a C OSC . The triangle waveform has 95% duty
ratio and runs from 0.2V to 1.2V. Please refer to Figure 6 for
a specific frequency.
When external synchronization is required, use the following
circuit for connection. Always choose the converter self-
switching frequency 20% lower than the sync frequency to
accommodate component variations.
10
following control configurations:
1. ADJUSTABLE SOFT-START
In this configuration, the ramp-up time is adjustable to any
time longer than the building soft-start time of 2ms. The
approximate ramp-up time, T ST , is:
? V O ?
? V IN ?
Figure 18 shows the waveforms.
FN7360.5
November 5, 2007
发布紧急采购，3分钟左右您将得到回复。
相关PDF资料
ASPI-0630LR-6R8M-T15
INDUCTOR POWER 6.8UH 0630 SMD
A9CCG-1008F
FLEX CABLE - AFG10G/AF10/AFG10G
TARS336M006
CAP TANT 33UF 6.3V 20% AXIAL
EBC07DRAI
CONN EDGECARD 14POS R/A .100 SLD
RCM15DCSN-S288
CONN EDGECARD 30POS .156 EXTEND
TARS335K035
CAP TANT 3.3UF 35V 10% AXIAL
TH3D226M025E0600
CAP TANT 22UF 25V 20% 2917
EEC20DREN-S13
CONN EDGECARD 40POS .100 EXTEND
相关代理商/技术参数
EL7554IRE-T13
功能描述:IC REG BUCK SYNC ADJ 4A 28HTSSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program 标准包装:1 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:3.3V 输入电压:4.5 V ~ 24 V PWM 型:- 频率 - 开关:- 电流 - 输出:125mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-6 包装:Digi-Reel® 供应商设备封装:SOT-6 其它名称:MAX1836EUT33#TG16DKR
EL7554IRE-T7
功能描述:IC REG BUCK SYNC ADJ 4A 28HTSSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program 标准包装:1 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:3.3V 输入电压:4.5 V ~ 24 V PWM 型:- 频率 - 开关:- 电流 - 输出:125mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-6 包装:Digi-Reel® 供应商设备封装:SOT-6 其它名称:MAX1836EUT33#TG16DKR
EL7554IREZ
功能描述:直流/直流开关调节器 LDFREE 7554 6 AMP DC:DC STP DWNG RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5
EL7554IREZT13
制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:Monolithic 4 Amp DC-DC Step-Down Regulator
EL7554IREZ-T13
功能描述:直流/直流开关调节器 LDFREE EL7554 6 AMP DC:DC STP DWNG RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5
EL7554IREZ-T7
功能描述:直流/直流开关调节器 LDFREE EL7554 6 AMP DC:DC STP DWNG RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5
EL7556AC
制造商:ELANTEC 制造商全称:ELANTEC 功能描述:Programmable CPU Power Supply Unit
EL7556ACM
制造商:ELAN 功能描述: